AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Cut fingers on dji spark8/16/2023 The foam outer box (only the default Wi-Fi username and password can be found here).ġ.How long does it take to fully charge a battery?.The Settings option in DJI Assistant 2 or DJI GO 4.The battery compartment on the aircraft (only the default Wi-Fi username and password can be found here).There are three places where you can check this information: Where can I check the aircraft Wi-Fi’s username and password?. Users can manually choose between 2.4 GHz and 5.8 GHz or let DJI GO 4 choose a frequency band automatically. Can frequency bands be manually adjusted during video transmission?.When connected directly to a mobile device:Ī max height of 50 m and distance of 100 m.What is Spark’s effective transmission range?Ģ.4 GHz FCC: 1.2 mi (2 km) CE: 0.3 mi (500 m) SRRC: 0.3 mi (500 m) (unobstructed and free of interference)ĥ.8 GHz FCC: 1.2 mi (2 km) CE: 0.18 mi (300 m) SRRC: 0.7 mi (1.2 km) (unobstructed and free of interference).It is subject to the performance of your mobile device and signal interference. The video transmission latency to your mobile device is about 200 ms. What’s the latency of the Spark’s video transmission?.What’s the resolution of the Spark’s video transmission?.Spark can withstand wind speeds between 19‑24 mph (29‑38 kph). Once the rotors start spinning, centrifugal force will automatically unfold the propellers into the correct position. What happens if the propellers are not fully unfolded before flight?.Do I have to remove the propellers when storing or transporting Spark?.The remote controller is approximately 15 cm long, 8 cm high, and 6 cm thick. What are the dimensions of the remote controller?.The remote controller supports 2.4 GHz and 5.8 GHz dual‑band Wi‑Fi frequencies. What Wi-Fi frequencies does the remote controller support?.When you hear Spark beep, release this button. With Spark powered on, press and hold the battery power button. Once the controller starts beeping, release these buttons. Press the Pause, Fn, and C1 buttons at the same time. How do I link Spark to the remote controller?.It takes two hours to fully charge the remote controller for up to three hours of operation. How long does it take to fully charge the remote controller? How long is the battery life?.The remote controller firmware can be updated in DJI GO 4. How do I update the remote controller’s firmware?.The maximum speed at which Spark is able to sense obstacles is 3 m/s. Spark will automatically avoid obstacles up to 16 ft (5 m) in front of it. What is the maximum distance and speed at which the Spark can sense obstacles?.In this instance, the images captured are actually from the live stream with a photo resolution of 1024×768 and video resolution of 1280×720. The aircraft will store photos and videos on your mobile device. Can I capture photos or record video without a Micro SD card?.What are the recommended Micro SD cards for the Spark?.
0 Comments
Read More
Leave a Reply. |